Settings for print scan in simplex scanning, Duplex scanning – CNET ecopy Printer/Fax/Scanner/Copier User Manual
Page 122
Setting Originals
114
4
Settings for Print Scan in simplex scanning
• When you perform a Print Scan operation while scanning one side of an orig-
inal, set the original in the ADF as illustrated below, regardless of the width
of the originals.
• Select (1 Sided Orig.
→ 1 Sided Print) or (1 Sided Orig. → 2 Sided Print) to per-
form simplex scanning, by using [Duplex] under [5.Print Settings] on this ma-
chine. See p.79 “Duplex” for details.
Limitation
❒ When you select 2-sided print, the printout orientation is fixed to top to
top.
Duplex Scanning
When performing duplex scanning, place the originals in the ADF.
The setting orientation differs depending on whether the width of the original is
within or larger than 297mm (11.7”).
Original width
297mm (11.7”) or less
wider than 297mm (11.7”)
When placing originals
on the ADF
Place the original right side up,
top edge first.
Place the original right side up, in
such a way that the top edge is
set on the far side of the original
table.
When the original is bound on
either side:
When the original is bound on ei-
ther side:
Setting when the net-
work TWAIN driver is
used
Set [Orientation:] to
, [Side:]
to “ Duplex (Top to Top) ”, and
[Document:]
to “ ADF ”.
Set [Orientation:] to
, [Side:]
to “ Duplex (Top to Top) ”, and
[Document:]
to “ ADF ”.
ADG025S
www.cnet.ie