CNET ecopy Printer/Fax/Scanner/Copier - Manual (Page 187)

Troubleshooting
179
11
Some of the registered destina-
tions are not displayed on the des-
tination list. • Check if [All] is displayed at the top right corner of the
“ Select destination(s). ” screen.
If another title like [A], [B] or [Freq.] is on the screen, it
means that you have searched destinations using the
{{{{./*}}}} (Title) key, and only the matched destinations are
currently available for selection. In this case, press the
{{{{./*}}}} (Title) key, highlight [All], and then press [OK]. See
p.129 “To recall all available destinations” for details.
The e-mail destinations (including
Cc destinations) are cleared when
a file name is specified. When you perform a Send Scan operation, note the follow-
ing things.
• You cannot use the following functions at the same
time:
• Scan to E-mail (referred to as “e-mail function”
here)
• Scan to Folder (SMB) (referred to as “SMB function”
here)
• Scan to FTP (referred to as “FTP function” here)
When you select [File Name] and then press [Settings] on
the screen shown above, it means that you select either
of the SMB or FTP function, and the e-mail function is
disabled. Because of this, the e-mail destinations are
cleared automatically.lSpecifying [To:], [Cc:], or [Sub-
ject]
disables the SMB or FTP function. Specifying [SMB]
disables the e-mail and FTP function. Specifying [FTP]
disables the e-mail and SMB function.
Problem Possible Cause and Required Action
www.cnet.ie