CNET ecopy Printer/Fax/Scanner/Copier - Manual (Page 144)

Sending Scan File by E-mail
136
6
To start with an original on the exposure
glass
AAAA
Confirm that the E-mail standby
screen is displayed.
When “ Select destination(s).
” is displayed, no destination is se-
lected. Select a destination to dis-
play “
Ready ” on the screen.
BBBB
Press the
{{{{Start}}}} key.
Scanning the original on the expo-
sure glass starts.
Note
❒ To interrupt scanning, press the
{{{{Clear/Stop}}}} key.
After the original is scanned properly,
the message “
Set the next origi-
nal(s) and press the Start key,
or press [Finish] to complete.
” appears.
CCCC
Place the next original on the ex-
posure glass, and then press the
{{{{Start}}}} key.
DDDD
Repeat step CCCC as necessary.
EEEE
Press [Finish] when all the origi-
nals are scanned.
Note
❒ When “
Show Options after
Each Scan Job ” is selected for
[End of Scan Option] under
[2.Send Scan Settings] , a screen
for selecting the next operation
appears after you press [Finish].
When scanning finishes properly,
the e-mail is sent to the e-mail
(SMTP) server.
m appears at the
upper right corner of the screen
while the e-mail is sent.
Note
❒ You cannot perform any opera-
tions while m is displayed on
the screen.
❒ Do not turn the power of this
machine off while m is dis-
played on the screen.
m disappears when the e-mail has
been sent to the e-mail (SMTP)
server, and the E-mail standby
screen appears.
ABK007S
www.cnet.ie