Kenmore 200 - Manual (Page 47)

Darning
(T)
Stitch pattern:
(
2
) Needie thread tension
(1) Presser foot R:
® Pressure dial
23
3 t o 6
Autonnatic buttonhole foot
3
To sew
(T) Button holder
Seiect the pattern 23.
Puli the button holder (T) fully to the rear.
Place the garment under the foot. Press the up/down
needle button twice. Remove the fabric to the left to draw
both threads under the foot and put the fabric back under
the foot.
Lower the foot. Press the start/stop button, the machine
will lock stitch, sew rows of darning, lock stitch and stop
automatically.
Repeat sewing by turning the fabric to reinforce it.
Note:
The maximum size of darning is 3/4"{2 cm) long and 1/4"
(0.7 cm) wide.
(D Maximum length 3/4" (2 cm)
(3) Maximum width 1/4" (0.7 cm)
To sew a shorter darning
d) Reverse button
(5) Required length
To sew a darning less than 3/4" (2 cm) long, first
stop the machine after sewing the required length (D, then
press the reverse button
(¡). The required length (|) has
now been determined.
Now restart the machine and continue sewing until the
machine stops automatically.
To sew the same size darning
Simply restart the machine to sew another darning of the
same size.
To sew the next darn at a different size, press the cancel
key.
To adjust the evenness of darning
You can correct the unevenness of darning by pressing
t h e : + o r
key.
If the left corner is lower than the right side, press the
' key to correct it, and vice versa.
Note:
The default setting is 3.0.
Restart for the Same Size
Different Size iCancell
3
.
0
-
i Cancel!
41