Kenmore 200 - Manual (Page 84)

SECTION VII. NORMAL MAINTENANCE
CAUTION:
• Unplug the machine.
• Do not dismantle the machine other than as explained
in this section.
• Do not store the machine in a high-humidity area, near
a heat radiator, or in direct sunlight.
• Clean the outside of the machine with a soft cloth and
mild soap.
The model 19010 is equipped with dual sewing lights. One
is located behind the face plate and the other is on the
underside of the sewing arm.
Replacing the Light Bulbs
CAUTION:
As the light bulb could be HOT, protect your fingers when
you handle it.
To replace the light bulb behind the face cover
Open the face cover (T).
Remove the rubber lamp socket (3) from the lamp
hoider®.
Pull out the buib (4) from the socket (3).
Insert the new iight bulb to the socket, making sure to
align the pins (D with the holes on the socket.
Snap the sodiet back into the holder and close the face
plate.
® Face cover
(
2 ) Lamp socket
(3) Lamp holder
0 Light bulb
® Pins
•
• To replace the light bulb on the underside of the
sewing arm
Lay the machine on its badi. Remove the dear window 0
with the screwdriver as shown.
Puli out the rubber lamp socket (3) from the window.
Remove the iight bulb from the sodiet.
Insert a new buib into the socket, making sure to align the
pins ® with the holes on the sockets.
Snap the socket back into the fork in the window.
Insert the window back into the opening on the machine.
0 Clear window
0 Lamp holder
0 Lamp socket
0 Light bulb
0 Pins
0 Holes
78