Kenmore 200 - Manual (Page 55)

28, 32, 70
3 to 4
Satin stitch foot
3
To Sew from the Beginning of a Combination
Pattern with Beginning Key
Example: pattern 30
® Stitch pattern:
(
2 ) Needle thread tension
(1) Presser foot F:
0 Pressure dial
• To sew
Press the key.
Seiect pattern 28.
Select pattern 32.
Select pattern 70.
Start to sew
0
.
Press start/stop key in the middle of a programmed
pattern @.
Press the
e key.
The entire memorized pattern shows up 0.
You can start sewing the combination pattern from the
beginning.
Twin Needle Sewing
Notes:
• When you sew patterns with the twin needle, test the
stitches first before you try.
Use zigzag foot or satin stitch foot for twin needle
sewing. Try satin stitch foot when zigzag foot makes a
wrinkled appearance and distorted pattern on the fabric.
• Do not set the stitch width at more than 3.5, otherwise
the needle will hit the needle plate and the needle will
break.
• You can not sew the following patterns with twin needle,
the message 0 appears on the visual touch screen if
you seiect one of them:
3, 15, 16, 17, 18, 19, 20, 21, 22, 23, 24, 25, 51,
86 , 87,
88 , 89, 90, 97, 98, 99, 110, 113, 116, 120, 121, 123,
124, 125, 126, 127 and 128.
To sew
Insert an additional spool pin, and put a felt on the spool
pin. Draw both threads from the spools and pass them
through the points from 1 to 5.
Make sure that the two strings of thread from the spools
will not get tangled.
Slide one of the threads through the needle bar thread
guide on the left, and the other one on the right.
Thread the needles from the front to back.
Press the twin needle key 0
.
Seiect the desired pattern and sew.
Notes:
• Make sure each of the threads wind off from the spools
as shown.
• The built-in needle threader cannot be used for the twin
needle.
• When changing the sewing direction, raise the needle
and turn the fabric.
:^7o SJ:
1 ^
i;
! Hemstitch n 3—4-1.
3/7
Decorative
11,1
3/7
B
Decorative
3 / h
49