F. connect inlet hoses to water faucets – Kenmore Washer/Dryer User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
STEP 2. Attach the hose with the red
coupling to the hot water (bottom) inlet
valve. Attaching the red coupling first
makes it easier to tighten connection
with pliers. Screw on coupling by hand.
Make an additional two-thirds turn with
pliers to tighten coupling. DO NOT
OVERTIGHTEN; this could damage
the valves.
F. CONNECT INLET HOSES
TO WATER FAUCETS
STEP 1. Make sure washer basket is
err pty. Run water through both faucets
into a bucket or laundr/ tub to get rid of
oa"tides in the water lines that might
clog hoses. Determine which faucet is
not: and which is cold. Mark the hot water
fatcet.
STEP 3. Attach the hose with the blue
coupling to the cold water (top) inlet
valve. Screw on coupling by hand. Make
an additional two-thirds turn with pliers
to tighten coupling. DO NOT OVER
TIGHTEN; this could damage valves.
STEP 2. Attach the hose with the red
coupling to the hot water faucet. Screw
on coupling by hand. Make an additional
twc-thirds turn with pliers to tighten coupling.
DO NOT OVERTIGHTEN; this could
damage the coupling.
STEP 3. Attach the hose with the
blue coupling to the cold water faucet.
Screw on coupling to faucet by hand.
Make an additional two-thirds turn with
pliers to tighten coupling. DO NOT
OVERTIGHTEN; this could damage
the coupling.
STEP 4. Turn on water faucets and
check for leaks. A small amount of
water will enter the washer. You will
drain this later.
If you have:
You will need to buy:
Water faucets beyond the
2
longer water fill hoses: 6 ft. hoses,
reach of water fill hoses
Pad No. 76314 or 10 ft hoses,
Pad No. 350008
Parts listed are available from your local Sears store or Sears Service Center.
Call 1-800-366-PART (1-800-366-7278).
30