To remove and clean the – Kenmore Washer/Dryer User Manual
Page 43
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
• Start the washer. Bleach will be diluted
automatically before it comes in contact
with the wash load.
NOTE:
Do not use this dispenser to add
powdered chlorine or color-safe bleach
to your wash load. The dispenser is for
liquid chlorine bleach only.
Liquid
chlorine
bleach
dispenser
USING THE LIQUID FABRIC
SOFTENER DISPENSER
After loading the washer, measure and
add the recommended amount of fabric
softener into the dispenser. Follow
manufacturer's directions.
NOTE:
Pouring too much fabric softener
into the dispenser will cause the fabric
softener to dispense instantly into the
load due to siphoning action. This instant
“dump” could damage fabrics and will
make it appear that your dispenser is not
working correctly.
NOTE:
Fabric softeners are not com
patible with detergents. This dispenser
should never be used in the PREWASH
Cycle since it would dispense fabric''
softener into a wash load that has not
been rinsed. Undiluted fabric softener
spilled on fabric may result in spots that
look like oil stains.
If you ever use your dispenser this way
by mistake, rewash the load with extra
detergent to remove these deposits.
To Remove and Clean the
Fabric Softener Dispenser
STEP 1.
Grab the dispenser with both
hands. Squeeze and push upward with
thumbs.
STEP 2.
Flush the dispenser with
warm water
STEP
3. Replace dispenser after
cleaning.
Liquid fabric softener
dispenser
' Add warm water to fiil the dispenser
until it reaches the crossed opening at
the bottom of the funnel-shaped portion
of the dispenser.
■ Fabric softener is dispensed into the
first deep rinse water automatically.
43