Kenmore Washer/Dryer - Manual (Page 31)

G. SECURE DRAIN HOSE H. LEVEL LAUNDRY CENTER
/or 1/oiif Benefit
Securing the drain hose properly will
protect your floors from damage due
to water leakage.
STEP 1. Move laundry center to its final
location.
STEP 2. Locate the remaining piece
of shipping strap (not the end with
the three cotter pins) from STEP 3 of
“REMOVE SHIPPING STRAP.” Use
it to wrap the drain hose together with
the laundry tub or standpipe. Push
fastener into the nearest hole in the
shipping strap.
If the water faucets and drain standpipe
are recessed, put hooked end of drain
hose in standpipe. Tightly wrap the
shipping strap around the drain hose
and water inlet hoses (not the handles
or stems). Push fastener into the
nearest hole in the shipping strap.
for your
Benefit
Leveling your laundry center
properly prevents excessive
noise and vibration.
STEP 1. Tilt laundry center forward
until rear of laundry center is at least
3 inches off floor. You may hear the
self-adjusting rear legs click into place.
Lower laundry center to floor. Check
levelness of the laundry center by
placing a leve on top of the washer,
first side-to-side; then front-to-back.
STEP 2. If laundry center is not level,
prop up the front of the laundr/ center
and adjust the legs up or down as
necessary. Lower laundry center and
reset self-adjusting rear legs (as in
STEP 1). Repeat STEP 2 until the
laundry center is level.
NOTE: Do not tighten the front leg nuts
until after you have connected your
exhaust system (see pages 32-36).
31