Sharp Aquos LC 46SE94U - Manual (Page 13)

Preparation
Using the Remote Control Unit
Use the remote control unit by pointing it towards the remote control sensor on the
TV. Objects between the remote control unit and the remote control sensor may
prevent proper operation.
Do not expose the remote control unit to shock, in addition, do not expose the remote
control unit to liquids, and do not place In an area with high humidity.
Do not install or place the remote control unit in direct sunlight. The heat may cause
deformation of the remote control unit.
The remote control unit may not work properly if the remote control sensor on the TV is in
direct sunlight or strong lighting. In such cases, change the angle of the lighting or the TV,
or operate the remote control unit closer to the remote control sensor.
Antennas
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections
that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector,
plug it into the antenna terminal at the rear of the TV set.
1 .A 75-ohm system is generally a round cable with an
F-type connector that can easily be attached to a terminal
without tools (commercially available).
F-type connector
i
—I—№- -ohm coaxial cable (round)
2. A 300-ohm system Is a flat ‘TA/ln-lead" cable that can be
attached to a 75-ohm terminal througti a 300/75-ohm
adapter (commercially available).
” 300-ohm twin-lead cable (flat)
F-type connector should be finger-
“klk Jill"“ tightened only.
When connecting the RF cable to the TV set, do not
tighten the F-type connector with tools.
If tools are used, it may cause damage to your TV
set, (The breaking of internal circuit, etc.)
75-ohm coaxial cable
V.
12