Attaching thé stand – Sharp Aquos LC 46SE94U User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
QUSCK REFERENCE
I
LC-46SE94U/LC-52SE94U
Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
Confirm that there are 4 screws and a screwdriver
supplied with the speaker unit.
Insert the projections on the speaker unit into the
corresponding slots on the TV, then fasten the screws.
Screwdriver
Soft cushion
\
Insert and tighten the 4 screws with the screwdriver
{supplied with the product) in the order of
0
, (
2
),
@ and
0
.
Attaching thé Stand
Connect the ends of the cables to the speaker
terminals as shown below.
Connect the leads to the speaker terminals of the
same color.
fSsW^
* To detach the speaker unit, perform the steps in reverse
order.
* Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
» Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
•
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
Confirm that there are 12 screws (all the same size)
supplied with the TV,
f f f f f f f f f f f f
S
Set the post for the stand unit onto the box.
Attach the base to the post.
Insert and tighten the
8
screws into the
8
holes
on the bottom of the base.
Hex key-
'5f
© Insert the stand into the openings on the
bottom of the TV.
0 Insert and tighten the 4 screws into the 4 holes
on the rear of the TV.
- Hex key
«
n-
- Screws
|fS|^
® To detach the stand, perform the steps in reverse order.