CNET CWR-854 - Manual (Page 34)

34
3.3.5 WDS Settings
When selected in the Basic Settings page and enabled here, Wireless Distribution System (WDS)
enables the router to be used as a wireless bridge. Two Wireless-G Routers in bridge mode can
communicate with each other through their wireless interfaces. To accomplish this, all wireless
routers should be set to the same channel and the MAC address of other AP / Routers should be
entered in the table.
 Enable WDS: enable WDS function.
 Add WDS AP: Fill in the other AP/router’s MAC address what you want to bridge.
 Comment: This field is used for adding any comments.
 Apply Changes: This button is used to apply new settings
 Reset: To undo all changes.
 Set Security: To setup wireless security for WDS.
 Show Statistics: Shows the MAC address, transmission and reception packet
counters for each configured WDS AP.
 Current WDS AP List: A table showing current WDS AP’s.
 Delete Selected: Delete the selected WDS AP.
 Delete All: Delete all the WDS APs.
 Reset: Click on “Reset” to undo changes.
Notes: Please set the wireless mode to “WDS” or “AP+WDS” first. (Wireless  Basic
Setting)