CNET CWR-854 - Manual (Page 37)

37
3.4 TCP / IP Settings
Please follow the following instruction to build the network connection between the wireless router
and your computers or network devices.
3.4.1 LAN Interface
This page is used to configure the parameters for local area network that connects to the LAN
ports of your WLAN Broadband Router. Here you may change the setting for IP address, subnet
mask, DHCP, etc.
 IP Address: Fill in the IP address of LAN interfaces of this WLAN Access Point.
 Subnet Mask: Fill in the subnet mask of LAN interfaces of this WLAN Access
Point.
 Default Gateway: Fill in the default gateway for LAN interfaces out going data
packets.
 DHCP: Click to select Disabled, Client or Server in different operation mode of
wireless Access Point.
 DHCP Client Range: Fill in the start IP address and end IP address to allocate a
range of IP addresses; client with DHCP function set will be assigned an IP
address from the range.
 Show Client: Click to open the Active DHCP Client Table window that shows
the active clients with their assigned IP address, MAC address and time expired
information. [Server mode only]
 Static DHCP: Select enable or disable the Static DHCP function from pull-down
menu. [Server mode only]
 Set Static DHCP: Manual setup Static DHCP IP address for specific MAC
address. [Server mode only]
 Domain Name: Assign Domain Name and dispatch to DHCP clients. It is optional
field.
 802.1d Spanning Tree: Select enable or disable the IEEE 802.1d Spanning Tree
function from pull-down menu.
 Clone MAC Address: Fill in the MAC address that is the MAC address to be
cloned.
 Apply Changes: Click the Apply Changes button to complete the new