CNET CWR-854 - Manual (Page 36)

36
3.3.7 WPS
This page allows you to change the setting for WPS (Wi-Fi Protected Setup). Using this feature
could let your wireless client automically syncronize it’s setting and connect to the Access Point in
a minute without any hassle. CWR-854 could support both Self-PIN or PBC modes, or use the
WPS button (at real panel) to easy enable the WPS function.
Notes: About the WPS button that please refer to the “Real Panel Description”.
 Disable WPS: WPS will be disabled when clicked
 WPS Status: Show WPS status is Configured or Unconfigured.
 Self-PIN Number: Fill in the PIN Number of AP to register the wireless distribution
system access capacity.
 Push Button Configuration: The Start PBC button provides tool to scan the
wireless network. If any Access Point or IBSS is found, you could connect it
automatically when client join PBC mode.
 Apply Changes: Click the Apply Changes button to complete the new
configuration setting.
 Reset: Click the Reset button to abort change and recover the previous
configuration setting.
 Current Key Info:
 Authentication: It shows the Authentication is opened or closed.
 Encryption: It shows the Encryption mode.
 Key: It shows the Encryption key.
 Client PIN Number: Fill in the Client PIN Number from your Client sites.