Uniden UH-100 - Manual (Page 18)

Channel Seeking Operation
Unlike normal scanning, CHANNEL SEEK Is used more often when checking for active
channels.
If a signal is detected, while seeking, the UH-100 will tune to that signal for 4 seconds
only and then resumes Seeking Operation.
Changing from SCAN to SEEK Mode operation.
1. Firstly, activate SCAN mode.
3S
2. Press and hold SCN until a "beep" is heard. The SCN
icon starts to flash.
^Ll U
3. If an active channel is detected the UH-100 will stop on
that channel for 4 seconds, (eg. CH17)
'/fi. / #
'nS£3Sun. » »
4. After 4 seconds, the UH-100 will start seeking again
for active channels.
Lf
5. If you find the channel interesting, simply press either
the PTT switch or the SCN key to stop the operation
before the 4 second timer elapses.
I
Iff bb III I
VT6.ffS0«» • W
When SCN Is pressed again SEEK is still the mode of operation.
To change back to SCAN, while SEEKING, press and hold
SCN until a beep is heard. The SCN icon stops flashing.
n n
‘ L I U
Note: SEEK checks the same channel stored in SCAN memory. Thus, you can Seek
either in OS or GS Mode.
17