2-1. receiver operation, 2-2. frequency selection, 2 receiver operation – Kenwood TH-27A User Manual
Page 15: Ctd cid co co, Luu c c
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Audio confirmation is provided whenever a front panel
key is depressed. You can disable this function by
pressing the F key for longer than 1 second, then pressing
the 1 key.
4-2-1. Receiver Operation
Connect the battery pack and the supplied antenna.
Set the controls as follows:
1. Press the power switch for longer than 0.3 second.
TH-27
series
4-2. RECEIVER OPERATION
TH-47
series
The frequencies shown above are the default frequencies after a
microprocessor reset. If the display shows incomplete data or you
think the displayed frequency is in error, reset the microprocessor
Memory Initialization on page 1 9.
2. Rotate the VOL control clockwise until a signal or
noise is heard coming from the speaker.
3. Rotate the tuning control to selected an open channel.
4. Rotate the SQL control clockwise until the noise just
disappears and the BUSY indicator turns off. This
point is known as the Squelch Threshold point.
5.
Select the desired operating frequency using the
tuning control. When a signal is received the S-meter
will deflect and the BUSY indicator will turn On.
4-2-2. Frequency Selection
• Direct Keyboard Frequency Entry
1. Press the ENT key to select the ENTER mode.
C
e
FQ
2. Within 1 0 seconds of pressing the ENT key enter the
frequency from most significant digit to the least
significant digit.
CTD
CID
CO
CO
[SEKI
lUU c c
I I I.JU
B
APO
Before entering 1 kHz digit this
indicator may flash.
The transceiver change frequency after 1 kHz digits have
been entered (1 kHz digit is not displayed).
If 1 kHz digit indicator flashes, enter the 1 kHz digit
frequency.
If you should make an error before entering all digits,
press the ENT key twice , and reenter all digits.
15