Kenwood TH-27A - Manual (Page 21)

NOTE
When the RX frequency is rewrited in the odd split
channel, the TX frequency of the channel will be
automatically erased.
• Odd split Call Channel
1. Select the desired CALL channel TX frequency.
2. Press the M key momentarily.
3. Press and hold the PTT switch and press the CALL key.
4. Release the PTT switch.
• To Confirm the Contents of the Split Channel
1. Press the memory channel number key. The pro­
grammed receiver frequency appears on the display
with " + ” and " —" offset direction indicator. This
indicates that this channel has an odd split entered.
CUD
2. To check the transmit frequency press the F key, then
SHIFT/REV key . The transmit frequency will appear
in the display. •
• Call Channel entry
1. Select the desired CALL channel frequency, tone data
etc.
2. Press the M key momentarily then press the CALL key
within 10 seconds of pressing the M key.
• Clearing a Memory Channel
If you want to clear the contents of an individual memory
channel use the following procedure.
1. Select the memory channel you wish to clear.
2. Press the M key. then ENT key.
3. The selected memory channel number will disappear.
4-4-6. Memory Channel Recall
NOTE
If nothing is stored in the channel, the memory
cannot be recalled and an error tone sounds.
One-digit Recall
The one-digit input mode is useful mainly to use only
channels 0 to 9. Any of channels 0 to 9 can be directly
recalled simply by pressing its number key. Then rotate
the Tuning control to select 1 0 to 39. To return to the
VFO mode, press that key again.
21