Kenwood TH-27A - Manual (Page 26)

CALL/VFO Scan
Press the F key, then the CALL/C.SCAN key in the VFO
mode to start alternate scanning of the VFO frequency
shown on the display and the call channel.
CALL/Memory Channel Scan
Press the F key, then the CALL/C.SCAN key in the
memory channel mode to start alternate scanning of the
CALL channel and the Memory channel that was last
used.
4-5-9. Memory Channel Lockout
This function allows you to specify which memory
channels you wish to skip during memory channel scan.
1. Select the memory channel that you wish to skip by
pressing the numeric keys.
2. Press the F key. The F indicator lights. Within 10
seconds of pressing the F key, press the O/L.OUT key.
A ★ indicator appears under the memory channel
number. This indicates that the memory channel will
be skipped in the memory channel scan mode.
CTD
L . O U T
CX3
4-5-8. CALL Scan 3. Repeat steps 1 and 2 to lock out any other channels
you wish to skip.
4. To cancel the lockout, select the desired memory
channel as described in steps 1, and 2 above. Press
the F key, then the O/L.OUT key. The ★ indicator goes
off.
4-5-10. Priority Alert Function
The priority Alert function allows you to monitor memory
channel 1 once every 5 seconds for activity even when
you are tuned to a different channel number.
• Alert by Warning Tone
If a signal is present beep will sound from the speaker
to indicate that the channel is busy.
To activate the priority alert function;
1. Ensure the frequency you wish to monitor has been
entered in memory channel 1.
2. Adjust the SQL control to the threshold point.
3. Press the F key momentarily, then press the 1 /AL key.
The AL indicator will turn on the display to indicate
that this function has been activated.
CUD
A L
CLD
lUC c
I IJ.ULI
AL B APO
26