6-1. transmitter offsets, 6-2. reverse function, 6. repeater operation – Kenwood TH-27A User Manual

Page 28

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

4-6-1. Transmitter Offsets

All amateur radio repeaters utilize a separate receiver
and transmit frequency. The receiver frequency may be
either above or below that of the transmit frequency. The
configuration of most repeaters will fall into one of the
categories listed below:

4-6. REPEATER OPERATION

TH-27A/E

TH-47A

TH-47E

+

+ 600 kHz

5 MHz

-t- 1.6 MHz

- 600 kHz

-5MHz

- 1.6 MHz

— —

-7.6MHz

• Offset Direction

To select the desired transmitter offset direction press
the SHIFT key. Each time you press the key the trans­
ceiver will advance from one direction to the other, i.e.
" + ” to " —”

” to

with European versions) to

no offset (simplex).

• Automatic Offset Selection (U.S.A., Canada and Ocea­

nia version)

The TH-27A has been programmed according to the
standard ARRL (Amateur Radio Relay League) Band Plan
with regard to transmitter offset direction. Please see the
accompanying chart for addition information on this

programming. You can, of course, override this by using

the SHIFT key if desired.

145.1 145.5 146.0146.4146.6 147.0 147.4 147.6 148.0

S : simplex

4-6-2. Reverse Function

Some repeaters utilize a "Reverse Pair”, i.e. the trans-
mit/receive frequencies are exactly the reverse of an­
other repeater. For example repeater A uses 1 46.000
for a transmit frequency (INPUT) and 146.600 for a
receiver frequency (OUTPUT). Repeater B might use

146.600 for a transmit frequency and 146.000 for a

receiver frequency. It would be inconvenient to have to
reprogram the transceiver each time you wanted to use

these repeaters.
The SHIFT/REV key allows you to easily reverse the
transmit and receiver frequencies. To use the REV
function press the F key, then the SHIFT/REV key. The

R indicator will turn on in the display to remind you that

you are working a reverse pair.

To return to normal press the F key, then SHIFT/REV key
again. The R indicator will turn off.
This function is also useful to check the input frequency
of the repeater so that you can determine if you are
within range for simplex communications.

28

Advertising
This manual is related to the following products: