Kenwood TH-27A - Manual (Page 40)

Waiting with group code.
3. When you are called with the group code, the
common group code and its memory channel number
are displayed.
(Example; For member 2, group code 789 is stored in
memory for CH 2.)
P indicator flashes Group code
This code becomes a number other than 0 to
indicate group calling.
4. When the PIT switch is pressed, group code 789 (as
displayed) and your station ID code are transmitted.
You can participate in the group roundtable.
After the remote station has been called, cancel paging.
Communication can be performed more efficiently.
(A code is locked out only during reception with the
paging function.)
If an individual code is stored in each of memories 1 to
9, reception is enabled when the codes match, even if
one remote station communicates with another. To use
memories 1 to 9 for transmission only, lock out the
memories.
When the local station is communicating with two or
more groups having the same frequency, lock out the
group code with which stand by is temporarily stopped.
(Group calling is possible.)
• Paging Memory Lockout
1. Enter THE CODE SETTING MODE and display the
memory channel number (except memory 0) to be
locked out using the tuning control.
2. Press the M key. The ★ mark lights and the memory
is locked out.
3. To cancel, repeat steps 1 and 2.
4-9-5. Code Lockout
40