3. transmitter operation – Kenwood TH-27A User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

4-3. TRANSMITTER OPERATION

NOTE

1. Ensure that an antenna with a low standing wave

ratio (less than 1.5 SWR) is attached to the
antenna connector before attempting to transmit.

Failure to provide proper termination may result

in damage to the final amplifier section.

2. Always check that the frequency is clear before

transmitting.

1. Select the desired operating frequency using any of

the methods previously discussed.

2. Check the frequency to see if it is occupied before you

transmit.

3. Press the PTT switch. The ON AIR indicator will light,

and the battery level meter will light.

4. Speak into the microphone. The recommended dis­

tance to the microphone is 5 cm (2 inches).

NOTE

Talking closer may result in overdeviation of your
transmit signal, which might be reported as a loss

of clarity or an excessively wide transmit signal.

Talking too far away may result in reports of
weak audio.

5. Release the PTT switch to return to the receive mode.

The ON AIR indicator should go out, and the battery

level meter will return to zero.

■ Time Out Timer
The transceiver has a time-out timer function to prevent

possible problems caused by continuous transmission.

This function forcibly stops continuous transmission
after 1 0 minutes. When the timer times out, the trans­
ceiver beeps and automatically returns to the RX mode.

Press the PTT switch to transmit again.

■ TX. STOP

Pressing the M/TX.S key within 1 0 seconds of pressing

the F key will set the TX. STOP function on or off.
■ Changing Transmitter Output Power

Pressing the LOW key will allows you to select 4 different

transmitter output power levels. The actual transmitter
output power for this unit depends on the power supply

being used.

• H (High power): For maximum output power.
• M (Medium power)
• L (Low power): For short-distance communication.
• EL (Economic Low power): For line-of-sight short-

distance communication.

Output Power

TH-27A/27E

TH-47A/47E

L

EL

H

M

H

M

PB-13

2.5

2

2

1.5

0.5

20

Manganese Battery

5

2.5

5

2.5

0.5

20

Alkaline Battery

2.5

2

2

1.5

0.5

20

18

Advertising
This manual is related to the following products: