Service tpm system message – Chrysler 2015 Country - Owner Manual User Manual

Page 542

Advertising
background image

The system will automatically update, the graphic dis-

play of the pressure value(s) will stop flashing, and the

“Tire Pressure Monitoring Telltale Light” will extinguish

once the updated tire pressure(s) have been received.
NOTE:

The vehicle may need to be driven for up to 20

minutes above 15 mph (24 km/h) to receive this infor-

mation.
SERVICE TPM SYSTEM Message
The “Tire Pressure Monitoring Telltale Light” will flash

on and off for 75 seconds, and remain on solid when a

system fault is detected. The system fault will also sound

a chime. The EVIC will display a “SERVICE TPM SYS-

TEM” message for a minimum of five seconds. This

message is then followed by a graphic display, with - - in

place of the pressure value(s) indicating which TPMS

Sensor(s) is not being received.

If the ignition switch is cycled, this sequence will repeat,

providing the system fault still exists. If the system fault

no longer exists, the “Tire Pressure Monitoring Telltale

Light” will no longer flash, the “SERVICE TPM SYSTEM”

message will not be present, and a pressure value will be

displayed instead of dashes. A system fault can occur by

any of the following scenarios:

• Jamming due to electronic devices or driving next to

facilities emitting the same radio frequencies as the

TPMS sensors.

• Installing some form of aftermarket window tinting

that affects radio wave signals.

• Accumulation of excessive snow and/or ice around

the wheels or wheel housings.

• Using tire chains on the vehicle.
• Using wheels/tires not equipped with TPMS sensors.

540 STARTING AND OPERATING

Advertising
This manual is related to the following products: