Cabletron Systems SPECTRUM TRMMIM - Manual (Page 25)

Using the Hub View 2-9
Using the TRMMIM Hub View
2. Drag down to Port Display Form, then right to select one of the port display
options. The current selection will be displayed in the Port Display Form text
box(es) on the module display.
Port display form options are:
Frames
Shows the total number of frames transmitted by the port, in a frames/second
format.
Total Bytes
Shows the total number of bytes transmitted by the port, in a bytes/second
format.
Errors
Shows port traffic errors as a rate (errors/second). You can display any one of the
following types of errors:
• Total errors
• Isolating errors
• Non-isolating errors
• Line errors
• Burst errors
• AC errors
• Abort Sequence errors
• Internal errors
• Lost Frame errors
• Rx Congestion errors
• Frame Copied errors
• Token errors
• Frequency errors
For error type descriptions, see Checking Statistics , page 2-22 .
Port Type
Provides the following administrative information about the port:
• Admin/Link Status indicates the Administrative and Link connection status
of the ports:
- ENB (Enabled) indicates that the port has been enabled by management,
but there is no station linked to the port.
- BYP (Bypassed) indicates the port has been disabled by management.
NOTE
When a device is reset, statistics windows and/or statistics displays in the Hub View may
display very large numbers for one polling interval. This is due to the resetting of the
counters.