Cabletron Systems SPECTRUM TRMMIM - Manual (Page 52)

Ring Map
3-2 Launching the Ring Map
Launching the Ring Map
To launch the Ring Map application
from the icon:
1. Click on the appropriate TRMMIM icon to display the icon menu.
2. Drag down to Ring Map and release.
from the Hub View:
1. Click on to display the Device menu.
2. Drag down to Ring Map and release.
from the command line (stand-alone mode):
1. From the appropriate directory, type the following at the command line:
spmarun e5map <IP Address> <community name>
The Ring Selection window, Figure 3-1 , will appear.
NOTES
The spmarun script invoked first in the above command temporarily sets the environment
variables SPMA needs to operate; be sure to use this command any time you launch an
application from the command line. This script is automatically invoked when you launch
an application from the icon menu or from within the Hub View.
If you wish to configure a station while in the Ring Map window, be sure to use a
community name
with at least Read/Write access. If you only wish to view the ring map,
a community name with Read access will be sufficient.
If there is a hostname mapped to your TRMMIM’s IP address, you can use <hostname>
in place of <IP address> to launch this application. Please note, however, that the
hostname is not the same as the device name which can be assigned via Local Management
and/or SPMA; you cannot use the device name in place of the IP address