Campbell Hausfeld CE7000 - Manual (Page 14)

Operating Instructions
www.CH-Commercial.com
Maintenance (Continued)
CoMponentS
Turn off all power and clean the cylinder
head, motor, fan blades, air lines,
intercooler and tank on a monthly basis�
BeltS
Lock out and tag the
power then release all
pressure from the tank to prevent unexpected
movement of the unit.
Check belt tension every 3 months�
Adjust belt tension to allow 3/8 inch to
1/2 inch deflection with normal thumb
pressure� Also, align belts using a straight
edge against the face of the flywheel and
touching the rim on both sides of the
face� The belts should be parallel to this
straight edge (see Figure 20). Dimension
A should be the same as B and C to ensure
proper alignment of the belts�
Slots in the bed-plate allow for sliding
the motor back and forth to adjust belt
tension�
A B
C
figure 20 - top view
Air Compressor
Motor
Flywheel
Straight Edge
Setscrew
Motor Drive
Pulley
MAintenAnCe SCHedule
operation daily Monthly 3 Months
Check Safety Valve l
Drain Tank (see Figure 16 or Figure 17) l
Check Oil Level l
Clean or Change Air Filter l
Check Intercooler l
Clean Unit Components l
Check Belt Tightness l
Change Oil (see Figure 14) l
14