Futaba 4GWD - Manual (Page 15)

16
Bef
ore Using
Charging The Battery (for NiCd battery system)
NiCd battery
NT8F700B
Charging the NiCd Battery
1 Plug the transmitter cord of
the special charger into the
charging jack on the side of the
transmitter.
2 Plug the charger into an AC
outlet.
3 Check that the charging LED
lights.
Charger
Transmitter charging
LED
Cord to transmitter
charging jack
When charging the NT8F700B NiCd battery with the special charger, allow about
15 hours for charging. If the transmitter has not been used for some time, cycle the
battery by charging and discharging it two or three times.
AC outlet
ｊ Always use the special charger or a
quick charger for digital proportional
R/C sets to charge a digital proportional R/C
set NiCd battery.
Overcharging a NiCd battery can result in burns, fire,
injuries, or loss of sight due to overheating, breakage, or
electrolyte leakage.
ｌ Never plug it into an outlet other than
indicated voltage.
Plugging the charger into the wrong outlet may result in
an explosion, sparking, or fire.
ｌ Do not insert and remove the charger
when your hands are wet.
It may cause an electric shock.
ｎ Warning
Special
Chager
ｊ
- Always use an NT8F700B NiCd battery.
Charging
jack