Futaba 4GWD - Manual (Page 23)

24
Functions
Functions
End point adjuster/EPA
Use this when performing left and right steering angle adjustments, throttle high
side/brake side operation amount adjustment, channel 3 servo up side/down side
operation amount adjustment, and shift servo left side/right side operation amount
adjustments during linkage.
- Corrects the maximum steering angle and left and right steering angles when there is a difference in the turning
radius due to the characteristics, etc. of the vehicle.
Maximum steering angle
The EPA function basically determines the maximum steering angle of each
channel. The Sub trim function may have been adjusted, or the operating range
set by EPA function may be exceeded. Check the linkage each time the Sub trim
function is adjusted.
(Initial screen)
Press "SEL" key to select the
desired function screen.
Calling the setup screen
[Adjustment range]
0~120% (each channel, each direction)
Initial value: 100%
[Adjustment buttons]
- Use the (+) and (-) keys to make
adjustments.
- Return to the initial value by pressing
the (+) and (-) buttons simultaneously
(approx. 1 sec).
[Setup items]
C1-L.F.U : Steering (left side)
C1-R.B.D : Steering (right side)
C2-L.F.U : Throttle (forward side)
C2-R.B.D : Throttle (brake side)
C3-L.F.U : 3rd channel (up side)
C3-R.B.D : 3rd channel (down side)
C4-L.F.U : Shift (left side)
C4-R.B.D : Shift (right side)
(Setup screen)
Press "CH" key to select the next set-
up screen.
ｎ Warning
ｊ Make sure that unreasonable force is not applied to the
servo horn during each channel operation.
If unreasonable force is applied to the servo horn, the servo may malfunction
and the model may run out of control.