Futaba 4GWD - Manual (Page 20)

21
Initial Set-Up
Initial Set-Up
Preparations
Before setting the transmitter functions, check and set items below:
Turn on the transmitter power.
Model number Model name
Battery voltage
Display when power switch is turned on
Digital Trims Initial Set-Up
Operate the DT1-DT4 levers and check if each trim value on the screen changes.
After checking each trim, set the trim value to the center (0) position.
Steering trim
position
Throttle trim
position
Aux. ch trim
position
Shift trim
position
Set-Up Procedure When Installed In a Car
When installing the servos in a car, performing function set-up in the following
order is recommended.
1 Set up the servo trims: see the above mentioned "Digital Trims Initial
Set-Up".
2 Set the servo direction of operation using the Reverse function: see p.
27.
*The servo installation method and linkage direction depend on the kit. Therefore, the servo operation
direction may have to be reversed relative to transmitter operation. Before installing the servo, check the
operating direction and set it using the Reverse function.
3 Set the subtrim and adjust the servo neutral point: see p. 26.
4 Set EPA of each channel and adjust the servo throw (travel): see p. 24.