Futaba 4GWD - Manual (Page 17)

18
Bef
ore Using
Receiver
Crystal
When changing the frequency, use the
specified Futaba crystal set.
Antenna
Connectors
4: Shift servo (CH4)
3: Aux. Ch (CH3)
2: Throttle servo (CH2)
1: Steering servo (CH1)
B: Power connector
R124H receiver
For the receiver, servos, and other connections, see page 19.
For the installation precautions, see page 20.
Servo lead
Servo horn
Mounting flange
Servo
For the receiver, servos, and other connections, see page 19.
For the installation precautions, see page 20.
E.S.C.
Motor connector
Connects to the motor.
(Orange) is positive. (Blue) is negative.
If the motor rotates in the wrong
direction, interchange the connections of
this connector.
Nicd battery connector
Connects to the running Nicd battery.
(Red) is positive. (Black) is negative.
Receiver connector
Connects to the receiver throttle channel.
Miniature screwdriver
Accessory. Use to press the
pushbutton switch.
Checker LED
Power switch
Pushbutton
switch
MC230CR
(Orange)
(Blue)
(Black)
(Red)
Applicable motors
(Number of turns is criteria.)
•Use the MC230CR with a motor with 20T or more turns.
*If a motor with a number of turns smaller than the above is used, the heat
protector and overcurrent protection circuit may operate. The number of turns
of the motor is a criteria only. Depending on the running conditions, the
protection circuit may operate even if the condition above is satisfied.
NiCd battery 6~7 cells (7.2~8.4V)