Haltech E6K - Manual (Page 27)

21
Example 1: Connecting to the positive side of the fuel pump.
Example 2: Connecting to the negative side of the fuel pump.
It does not matter which example is used, both will operate correctly. Note that the orange
wires are connected internally within the loom when the relay is closed. As a result it does not
matter which orange wire is used to connect to the fuel pump.
1.3.12. Install and connect Optional Idle Speed Motor
If you are not using the Idle Speed Control, tie the loom connector back neatly in the engine
bay. If the engine has a suitable Idle Speed Motor then you may connect it to the wiring loom,
otherwise you can install a Haltech supplied idle air control motor. For details on how to
install and plumb the Idle Speed Motor, see Chapter 14.
1.3.13. Install and connect any Optional Outputs
If you are planning to use any of the Programmable Optional Outputs, install and connect
them now. Depending on what options you are using, the wiring will be different. For details
on wiring your particular options, refer to Section 4, E6K Outputs.
1.3.14 Connect the Trigger Sensor
If the engine has a reluctor type magnetic trigger device for either the main Trigger or the
Home signal, you will need to connect to the reluctor adaptor input wiring now. For details on
how to connect the main loom to the trigger, refer to Error! Reference source not found..