Haltech E6K - Manual (Page 43)

37
Nissan This trigger should be used when the standard Nissan trigger is used.
Number of Teeth
This field is only applicable if the trigger type is: Multitooth, Motronic. The Number
of teeth :
Multitooth The number of teeth on the multitooth wheel
Motronic The number of teeth on the motronic wheel including the missing teeth
Tooth Offset
This field is only applicable if the trigger type is: Multitooth, Motronic. The offset is
the number of teeth the synchronisation event occurs prior to the trigger
Home Window Teeth
This field is only applicable if the trigger type is Nissan. The home window teeth is
the number of teeth counted during the home window.
Nissan Tooth Offset
This field is only applicable if the trigger type is Nissan. The Nissan tooth offset is
used to delay the trigger event after the synchronisation event defined by home
window teeth.
Spark Mode
This field defines the ignition delivery used, the options are: Distributor, Direct Fire or
Twin Distributor.
Coils on 4-cylinder motor
This field is only applicable if the spark mode is Direct Fire and the number of
cylinders in the main set-up is 4. The options for this field are: 2 or 4. If 2 is selected
waste spark is used. If 4 is selected there is one coil for each cylinder.
Engine Type
This field defines the engine type: Piston or Rotary.
Output Type
This field defines the type of ignition signal with which the ECU will drive the igniter.
The options are:
Constant Duty This signal is used to drive intelligent igniter with internal dwell
control.
Constant Charge This signal is used to drive dumb igniters without internal dwell
control. This output type will not accurately control intelligent igniters.
WARNING:
THE CONSTANT DUTY OUTPUT TYPE SHOULD NOT BE USED TO
DRIVE DUMB IGNITERS SINCE SUCH IGNITERS DO NOT HAVE
DWELL CONTROL. DOING SO WILL RESULT IN TOTAL
FAILURE OF THE IGNITER.
Coil Charge Time (ms)
This field is only applicable when constant charge is selected. The value of this field
is a measure of time in milliseconds and can range from 0.1ms - 8.2ms Typical values
are about 4-5ms.