Haltech E6K - Manual (Page 75)

69
CHAPTER 10 PRINTING MAPS
10.1 The Print Function
You can print the maps and identification information to printers that accept IBM emulation
mode, such as IBM compatible dot matrix printers (consult your printer manual). The Print
function should work with other IBM compatible printers, but some special characters such as
°, ±, etc. may not print correctly. Select the print function by pressing
p p p p
from the Options
sub-menu
The system will present you with options on which data you wish to print. There are four
options. Their meaning is as follows:
Set-up Information
This will print only the set-up pages (ie. Fuel, Main and Ignition pages).
Maps
Prints all the maps in the system (ie. Fuel, Ignition and Coolant).
Output Options
This function will print the current settings and the status of the
output options of the ECU. (ie. Turbo Wastegate).
Print All Information
This will print all of the above information
The system will ask for a name to print at the top of the printed output. This allows you to
differentiate between print-outs if you have printed more than one set of maps. The name can
be up to ten characters in length. Type in the name and press Enter (
¬ ¬ ¬ ¬
).
The system pauses to allow you to set up the printer. If you do not want to print you can leave
the print function by pressing
° ° ° °
. Pressing any other key starts the printing. Before you start
printing the printer must be ONLINE and must have power and paper. Once the printing has
started you can abort the printing by pressing
° ° ° °
.