Haltech E6K - Manual (Page 29)

23
CHAPTER 2 GETTING ONLINE
Now that your Haltech E6K is installed with all the sensors in place the system can be
connected to the programming computer. This will allow the readings from all the sensors to
be displayed on the screen and checked for correct operation.
To connect the PC to the Haltech E6K ECU you will need the programming cable and
programming disk supplied.
2.1 Connecting the Haltech E6K to a Computer
The programming cable supplied with the Haltech E6K is a standard serial link extension
cable. One end of the cable will plug into the Main Harness PC Interface connector (near the
main connector). The other end should plug into the mating connector at the back of your
computer. The plug on the computer may be marked "Serial", "Mouse" or "COM". Almost all
laptops will have this plug. If there is no 9 pin plug which it will connect to, check to see if
there is a 25 pin D-type plug available (some desk top computers will have this). If this is the
case, an appropriate cable can be supplied on request. Alternatively, most electronic retailers
will have a 25-pin to 9-pin converter.
Any time you wish to communicate with the E6K ECU it needs to be supplied with power.
This usually involves just turning on the ignition switch. If at any stage power is not on, or the
programming cable is disconnected while attempting to communicate, the programming
software will display the message RECONNECT HALTECH. To rectify this, reconnect
power and/or the programming cable.
You may now connect the Ignition Sub-Loom to the main wiring loom
2.2 Operating the Software
2.2.1 Computer Requirements
The computer required to program the Haltech E6K can be any IBM-PC compatible personal
computer from the XT onwards (i.e. the AT, 386, 486 or Pentium computers). The
requirements are fairly modest. The computer must have at least 640K of RAM (with about
590kb free for executable programs), one 3.5" disk drive and a CGA, EGA, or VGA screen.
(Virtually all reasonably modern laptops running MS-DOS (version 5.00 or higher) will fit
this description).