Haltech E6K - Manual (Page 31)

25
The Install program will now run. Follow the instructions given. The program will suggest
that the software will be placed in the HALTECH directory. You can change the destination
directory, but it is not recommended that you do unless you understand how directories work.
When it is finished, the installation program will tell you if the installation is successful. If it
was not, consult the trouble shooting section of this manual.
The E6K Program is now ready to run.
2.2.3 Running the Software from the Hard Disk
Boot your computer up as described earlier. If your computer is already on, make sure the C
drive is currently selected. To change to the HALTECH directory type :
cD \haltech¬
or, if you used a different destination directory, type that path.
To start the program type :
E6K¬
The E6K program will now run. The next section is on running the software from a floppy
drive. You can skip this section and go straight to the section entitled Azerty Keyboards.
2.2.4 Running the Software from the Floppy Disk
To run the software from a floppy drive, boot your computer up as described earlier. Insert the
Programming disk in the disk drive. If the drive is the A drive, then it must be currently
selected. To select the A drive (or B drive if it is the required drive) type :
a:¬
or
B:¬
You should now see the prompt :
A:\>_ or B:\>_
To start the E6K program type :
E6K¬
The E6K program will now run.