IC Realtime 4 Channel PoE Mobile Network Video Recorder - Manual (Page 126)

117
Parameter Function
Event
Type
Event type: There are four types. Local input/network input/IPC
external/IPC offline alarm.
Local input alarm: The alarm signal system detects from the
alarm input port.
Network input alarm: It is the alarm signal from the network.
IPC external alarm: It is the on-off alarm signal from the
front-end device and can activate the local NVR.
IPC offline alarm: Once you select this item, system can
generate an alarm when the front-end IPC disconnects with
the local NVR.
Alarm in Select corresponding alarm channel.
Enable You need to draw a circle here so that system can detect the alarm
signal.
Type There are two options: normal open and normal close. NO becomes
activated in low voltage, NC becomes activated in high voltage.
Period Alarm record function becomes activated in the specified periods.
There are six periods in one day. Please draw a circle to enable
corresponding period.
Select date. If you do not select, current setup applies to today only.
You can select all week column to apply to the whole week.
Click OK button, system goes back to alarm setup interface, please
click save button to exit.
Anti-dither System only memorizes one event during the anti-dither period. The
value ranges from 0 to 15s.
Relay Out Enable alarm activation function. You need to select alarm output port
so that system can activate corresponding alarm device when an
alarm occurs.
Alarm
Latch System can delay the alarm output for specified time after alarm ended.
The value ranges from 10 seconds to 300 seconds.
Record
Channel System auto activates current channel to record once an alarm occurs
(working with alarm activation function). Please note current device
shall be in auto record mode
Record
Latch System can delay the record for specified time after an alarm ended.
The value ranges from 10s to 300s.
Email Please draw a circle to enable email function. System can send out
email to alert you when an alarm occurs and ends.
Screen
display After enabled, alarm info will be prompted out on the local output end.
That is to say, the alarm prompt will be displayed beside the channel
name on the local surveillance image.
Buzzer Once you check the box here, the buzzer beeps when an alarm
occurred.
Tour Display the selected video in local monitor window. When alarm
occurs, system can begin one-window tour for the activated record
channel. Please set the tour time in the local end.