IC Realtime 4 Channel PoE Mobile Network Video Recorder - Manual (Page 73)

64
In the main menu, click setting, and then click Pan/Tilt Control button. The interface is shown
as in Figure 4-65. Here you can set the following items:
Channel: Select the current camera channel.
PTZ type: There are two types: local/remote.
Protocol: Select corresponding PTZ protocol(such as PELCOD)
Address: Default address is 1.
Baud rate: Select corresponding baud rate. Default value is 9600.
Data bit: Select corresponding data bits. Default value is 8.
Stop bit: Select corresponding stop bits. Default value is 1.
Parity: There are three options: odd/even/none. Default setup is none.
Figure 4-65
If you are connecting to network PTZ, the PTZ type shall be remote. See Figure 4-66.
Figure 4-66
After completing all the setting please click save button.
In one window display mode, right click mouse (click “Fn” Button in the front panel or click “Fn”