IC Realtime 4 Channel PoE Mobile Network Video Recorder - Manual (Page 128)

119
Parameter Function
Period Here you can set for business day and non-business day.
Anti-dither Range: 0 ～ 600
Alarm output: s. when an alarm occurred, system enables peripheral alarm device
Record channel
Select the recording channel (Multiple choices). This channel will be activated
to record when an alarm occurs.
Record Latch System can delay the record for specified time after an alarm ended. The
value ranges from 10s to 300s.
Send email System can send out email to alert you when an alarm occurs.
Tour Here you can enable tour function when an alarm occurs.
PTZ activation
Here you can set PTZ movement when an alarm occurs. Such as go to
preset, tour &pattern when there is an alarm.
Capture You need to input capture channel number so that system can backup
snapshot file when an alarm occurs.
6.4.2.2 PTZ
PTZ interface is shown as in Figure 6-43.
Please note, before operation please make sure you have set speed dome address and the NVR
and speed dome connection is OK.
Figure 6-43 PTZ
Please refer to the following sheet for detailed information.
Parameter Function
Channel
You can select monitor channel from the dropdown list. .
Protocol Select the corresponding dome protocol.(such as PELCOD)
Address
Set corresponding dome address. Default value is 1. Please note your
setup here shall comply with your dome address; otherwise you can
not control the speed dome.
Baud
Rate Select the dome baud rate. Default setup is 115200.