Interlogix TruVision IP Open Standards Outdoor Cameras Configuration Manual - Manual (Page 15)

1BChapter 2: Camera operation
TruVision IP Camera Configuration Manual 13
Parameters Description
SNMP Enable SNMP to get camera status and parameters related information.
802.1.X When the feature is enabled, the camera data is secured and user
authentication is needed when connecting the camera to the network.
QoS Enable to solve the network delay and network congestion by configuring the
priority of data sending.
FTP Specifies the FTP address and folder to which snapshots of the camera can
be uploaded.
Email Specifies the email address to which messages are sent when an alarm
occurs.
To define the TCP/IP parameters:
1. In the Network folder, click the TCP/IP subfolder to open its window.
2. Configure the NIC settings, including the NIC Type, IPv4 Address, IPv4
Subnet Mask, IPv4 Default Gateway, MTU settings, and Multicast Address.
3. If the DHCP server is available, check DHCP .
4. If the DNS server settings are required for some applications (e.g., sending
email), you should configure the Preferred DNS Server .
5. Click Save to save changes.
To define the port parameters:
1. In the Network folder, click the Port subfolder to open its window.
2. Set the HTTP port, RTSP port, and HTTPS port of the camera.
3. Click Save to save changes.
To define the DDNS parameters:
1. In the Network folder, click the DDNS subfolder to open its window.
2. Check Enable DDNS to enable this feature.
3. Select DDNS Type . Two options are available: DynDNS and IPServer.
• DynDNS: Enter the user name and password registered to the DynDNS
web site. The domain name is that of the DynDNS web site.
• IPServer: Enter the address of the IP Server.
4. Click Save to save changes.
To define the PPPoE parameters:
1. In the Network folder, click the PPPoE subfolder to open its window.
2. Check Enable PPPoE to enable this feature.
3. Enter User Name, Password, and Confirm password for PPPoE access.
4. Click Save to save changes.