Interlogix TruVision IP Open Standards Outdoor Cameras Configuration Manual - Manual (Page 32)

1BChapter 2: Camera operation
30 TruVision IP Camera Configuration Manual
time can be configured as No Pre-record, 5 s, 10 s, 15 s, 20 s, 25 s, 30 s or not
limited.
Post- record time
The post-record time is set to stop recording after the scheduled time or the
event. For example, if an alarm triggered recording ends at 11:00, and the post-
record time is set as 5 seconds, the camera records until 11:00:05. The post-
record time can be configured as 5 s, 10 s, 30 s, 1 min, 2 min, 5 min or 10 min.
To set up a recording schedule:
1. In the Storage folder, click the Record Schedule subfolder to open its
window.
2. Click the Enable Record Schedule box to enable recording.
Note: To disable recording, deselect the option.
3. Click Edit to edit the recording schedule. The following window appears:
4. Select whether the recording will be for the whole week ( All Day recording) or
for specific days of the week.
If you have selected “All day”, select one of the record types to record from
the drop-down list box:
• Normal: This is continuous recording.
• Motion detection: The video is recorded when the motion is detected.
• Alarm: The video is recorded when the alarm is triggered via the external
alarm input.
• Motion | Alarm: The video is recorded when the external alarm is
triggered or the motion is detected.
• Motion & Alarm: The video is recorded when motion and alarms are
triggered at the same time.