Snapshot parameters – Interlogix TruVision IP Open Standards Outdoor Cameras Configuration Manual User Manual
Page 29
1BChapter 2: Camera operation
TruVision IP Camera Configuration Manual
27
3. The delay time can be set to 5sec, 10sec, 30sec, 1min, 2min, 5min or 10min.
The delay time refers to the time duration that the alarm output remains in
effect after alarm occurs.
4. Click
Edit
to set the arming schedule for the alarm input. See “To set up
motion detection” for more information.
5. Click
Save
to save changes.
Snapshot parameters
You can configure scheduled snapshots and event-triggered snapshots. The
captured snapshots can be stored in the SD card (if supported) or the NAS (for
further information on NAS, please refer to “Configuring NAS settings” on page
28
).
You can also upload the snapshots to an FTP server.
Figure 14: Snapshot menu
Note:
If you have configured the FTP settings and check
Upload Picture
in the
FTP subfolder, the snapshots will be uploaded to the FTP. If you also check
Upload Snapshot
for motion detection or alarm input, the snapshots will be
uploaded to the FTP when motion detection or an alarm input is triggered.