Interlogix TruVision NVR 10 User Manual - Manual (Page 14)

Chapter 2: Installation
8 TruVision NVR 10 User Manual
Monitor connections
Connect the unit to a monitor via an appropriate cable with the VGA/HDMI connector.
See Figure 2 on page 7 for connecting a monitor to a TVN 10.
The TVN 10 supports at least 1024 × 768 / 60 Hz resolution. Adjust your monitor
accordingly to this resolution.
Audio inputs and output
The unit is equipped with one audio input and one audio output. Both the audio input
and the audio outputs are line-level
Audio input RCA jack, 315 mV, 40 kohms. Unbalanced
Audio output RCA jack, 315mV, 600 ohms. Unbalanced
Note: Line-level audio requires amplification.
Brackets
The TVNc models have a 1U desk-based chassis. They are not rack mountable.
The TVN models have a 1.5U desk-based chassis but can be easily rack-mountable
with the purchase of the TVR-RK-1 rack-mount kit. Contact your local supplier to order
the kit. See Figure 3 below.
Figure 3: TVN 10 rack-mount installation
To install the racks:
1. Attach the two small front-rack mount ears (A) to the NVR (supplied).
2. Attach the NVR to the front rails (B) (screws are not supplied).