Interlogix TruVision NVR 10 User Manual - Manual (Page 60)

Chapter 7: Network settings
54 TruVision NVR 10 User Manual
Checking network status
You can easily check network traffic in order to obtain information about the NVR such
as its linking status, MTU, sending/receiving rate, MAC address, and NIC type.
The Net Detect page shows the network traffic between the TVN 10 and your local
network. However, the traffic between the plug and play cameras and the TVN 10 is not
shown.
You can also check the network connection status by testing its delay and packet loss.
To check network traffic:
1. From the menu toolbar, click System Settings > Net Detect
2. Click the Traffic tab to display the Traffic window. The information displayed is
refreshed once a second.
To check network delay and packet loss:
1. From the menu toolbar, click System Settings > Net Detect .
2. Select the Network Detection tab.
3. Under the section “Network delay, Packet loss test”, enter the destination address
and click Test .
The test result appears in a pop-up window.
4. If you need to check the current network parameters, click the Network button to
get an overview.
To check network statistics:
1. From the menu toolbar, click System settings > Net Detect .
2. Select the Network Stat. tab.