Interlogix TruVision NVR 10 User Manual - Manual (Page 52)

Chapter 7: Network settings
46 TruVision NVR 10 User Manual
Option Description
NIC type The network interface card (NIC) is a device used to connect the NVR to
a network. Select the NIC type used from the drop-down list:
10M Half-dup, 10M Full-dup, 100M Half-dup, 100M Full-dup, 1000M
Full-dup, or 10M/100M/1000M self-adaptive (Default).
Enable DHCP Check this box if you have a DHCP server running and want your NVR
to automatically obtain an IP address and other network settings from
that server.
Default value is disable.
IPv4 Address Enter the IP address for the NVR.
Default value is: 192.168.1.82
IPv4 Subnet Mask Enter the subnet mask for your network so the NVR will be recognized
within the network.
Default value is: 255.255.255.0
IPv4 Default Gateway Enter the IP address of your network gateway so the NVR will be
recognized within the network. This is typically the IP address of your
router.
Default value is: 192.168.1.1
IPv6 Address 1 Enter the IPv6 address for the NVR.
Default value is: fe80::240:30ff:fe48:2975/64
IPv6 Address 2 Enter the IPv6 address for the NVR.
IPv6 Default Gateway Enter the IPv6 address of your network gateway so the NVR will be
recognized within the network. This is typically the IP address of your
router.
MAC Address Displays the MAC address.
MTU (bytes) Enter a value between 500 and 9676. Default is 1500.
Preferred DNS server Enter the preferred domain name server to use with the NVR.
Alternate DNS server Enter the alternate domain name server to use with the NVR.
Internal NIC IPv4 Address Displays the internal IP address of the on-board PoE ports. Default is
192.168.254.1
3. Click Apply to save the settings.
4. Click Back to return to live view, or continue configuring the NVR settings.
PPPoE setup
You can connect the NVR directly to a DSL modem. To do this, you need to select the
PPPoE option in the Network Settings menu. Contact your ISP to get the user name
and password.