Interlogix TruVision NVR 10 User Manual - Manual (Page 83)

Chapter 10: Live view
TruVision NVR 10 User Manual 77
Figure 18: Layout window
Table 10: Description of the layout window
Submenu name Description
General tab
1. Video Output Interface VGA/HDMI monitor is displayed. VGA and HDMI output from
the same port.
2. Window Segmentation Select which multiview layout will be default in live view
mode. Default is 2 × 2 multiview layout for the 4-channel
NVR, 3 × 3 multiview layout for the 8-channel NVR, and 4 × 4
for the 16-channel NVR.
3. Dwell Time Set the length of time for which a camera image is displayed
on the selected monitor before moving to the next camera
during sequencing. Default is off (“No switch”).
4. Enable Audio Out Check the box to enable/disable audio output. Default is
disable.
5. Event Output Designates which monitor will be the output to show the
event. Default is HDMI.
6. Event Full Screen Monitoring
Dwell Time(s)
Set the length of time for which an event appears on the
output monitor before moving to the next camera during
sequencing. Default is 10 seconds.
7. Alarm Full Screen Monitoring
Dwell Time(s)
Set the length of time for which an alarm appears on the
output monitor before moving to the next camera during
sequencing. Default is 10 seconds.
To set up the display options:
1. From the menu toolbar, click Display Mode Settings > Layout > General .
2. Specify the desired settings for each of the menu options.
3. Click Apply to save the settings.
4. Click Back to return to live view.