Interlogix TruVision NVR 10 User Manual - Manual (Page 70)

Chapter 9: Camera settings
64 TruVision NVR 10 User Manual
Plug and play cameras are configured automatically with default settings (see
Appendix D “Default menu settings” on page 139). When adjusting the settings of a
plug and play IP camera, the settings remain in place until the camera is
disconnected and reconnected. Upon reconnection, the camera automatically
returns to its default settings.
• Manual: Use this method if the IP cameras are located on a different LAN from the
NVR or are located on the internet.
See Figure 11 below for information on the IP camera window.
Figure 11: IP camera window
Network parameter window List of IP cameras found on the network
List of IP cameras added to the NVR.
The columns of camera information are: Camera no., Status, Edit, Advanced Set, View, Camera name,
IP Camera Address, Management Port, Protocol, Device Model, Serial Number, and Firmware.
1. Quick Add: Add the selected cameras from
the search results list to the NVR system
without modifying the camera configuration.
2. Search: Search the network for available IP
cameras.
3. Add: After entering the details of a camera in
the configuration window, add it to NVR
system.
4. Upgrade: Upgrade IP camera software. Insert
USB flash drive in NVR and select the file to
download. The camera will automatically
reboot once the software is upgraded.
5. Delete: Delete the selected IP camera.
6. Refresh: Update the information displayed on a
camera in the NVR device list.
7. Edit: Change the information on the selected IP
camera.
8. Live View: View the selected IP camera.
9. Camera status indication:
Green = Plug-and-Play cameras; Red =
Disconnected cameras; Yellow = No Plug-and-
Play cameras.