Interlogix DVR 60 User Manual - Manual (Page 135)

TruVision DVR 60 User Manual 129
Appendix A
Troubleshooting
Place the TVR 60 in well-ventilated space so that it operates within the allowed
range of temperature and humidity as in specification.
If the circuit board is wet, dust on circuit board can cause a short circuit. The
circuit board, plug and socket, housing fan and housing should be cleaned by
brushing regularly.
Table 22: Troubleshooting FAQs
Failure Possible reasons and actions to take
Why does the DVR make a
beeping sound after booting? The booting sound may be due to:
1. There is no HDD present in the DVR.
2. The HDD has not been initialized. See “Using the Setup Wizard” on
page 19.
3. The HDD is defective. Please contact your local supplier.
Why does the DVR not responsive
when using the remote control? If the DVR not responsive when using the remote control and you have
read through the section “Using the IR remote control” on page 26,
please check:
1. Check that the batteries are installed correctly in the remote control.
2. Check the remaining charge in the batteries.
3. Check that the remote control sensor is not covered.
4. Check the address setup in the DVR.
Why can the DVR not control the
PTZ dome camera through the
RS-485 port? If the PTZ dome camera does not respond:
1. Check that the RS-485 cable is properly connected and
undamaged.
2. Check that the correct type of camera dome decoder is being used.
3. Check that the camera dome parameters are correct.
4. Check that the address bit configuration of the camera dome
decoder is correct.
5. Ensure that the main board RS-485 interface is not damaged. If
damaged, please contact your local supplier.