Canon MARKLL WUX10 - Manual (Page 22)

Projector WUX10 MarkII User Commands
- 18 -
Revision History / Date Changes Revised by Approved by
AUTOPC
Auto PC
Format
AUTOPC
Environment
Power Input
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP VIDEO HDMI None
X O X X O O X X X X
Response
"i:OK" is returned if the control was executed properly.
For details on other responses, refer to the "Error List".
Description
(1) This executes Auto PC.
(2) This command is identical to pressing the “AUTOPC” button on the remote control.
(3) If the input is neither "A-RGB1" nor "A-RGB2", 'e:200X INVALID_SOURCE(***)' is returned
as an error response.
(4) If signals are not input, "e:2010 NO_SIGNAL" is returned.
(5) Execution of this command may modify the following setting values.
・ Total number of dots
・ Tracking
・ Horizontal/vertical positions
・ Number of horizontal/vertical display dots
(6) To confirm modified setting values, use the GET command of the respective parameter.
For details, refer to the GET commands below.
Setting GET
Total number of dots GET DOTS
Tracking GET TRACK
Horizontal position GET HPOS
Vertical position GET VPOS
Number of horizontal display dots GET HPIX
Number of vertical display dots GET VPIX
Example
> AUTOPC
< i:OK
* Commands are indicated by ">", and responses are indicated by "<".