Canon MARKLL WUX10 - Manual (Page 37)

Projector WUX10 MarkII User Commands
- 33 -
Revision History / Date Changes Revised by Approved by
FSTEPDRV
Focus lens step drive control
Format
FSTEPDRV=<Focus lens step control parameter:ID>
<Focus lens step control parameter:ID>
FAR This initiates focusing toward the far end.
NEAR This initiates focusing toward the near end.
Environment
Power Input
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP VIDEO HDMI None
X O X -
Response
"i:OK" is returned when focusing was completed successfully after step drive.
For details on other responses, refer to the "Error List".
Description
(1) This command is used to drive the focus lens.
(2) This command functions in the same way as when first the "FOCUS" button on the remote
control or main unit panel is pressed and then the "←" or "→" button is pressed.
(3) The amount by which the lens is focused is constant, and it is fixed for the system.
(4) If a focusing error occurs, step drive cannot be controlled.
(5) There are no GET commands available for this command.
Example
Control
> FSTEPDRV=NEAR 1-step control is exercised over the focus toward the NEAR end.
< I:OK
* Commands are indicated by ">", and responses are indicated by "<"..