Canon MARKLL WUX10 - Manual (Page 49)

Projector WUX10 MarkII User Commands
- 45 -
Revision History / Date Changes Revised by Approved by
LAMP
Lamp output setting
Format
LAMP=<Lamp output setting parameters:ID>
GET□LAMP / ?△LAMP
<Lamp output setting parameters:ID>
NORMAL Normal
SILENT Silent
cooling
Environment
Power Input
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP VIDEO HDMI None
X O X -
Response
"i:OK" is returned if the parameter was set properly.
For '
GET LAMP ' or ' ?LAMP ', current lamp output is returned as
'g:LAMP=<Lamp output setting parameters:ID>'
For details on other responses, refer to the "Error List".
Description
(1) This command is used to set the light quantity of the lamp to "NORMAL" or "SILENT"
(reduced light quantity appropriate for silent cooling).
(2) This command functions in the same way as when "Image adjustment" - "Lamp mode setting"
are selected on the menu.
(3) This sets the currently selected input signal and image mode.
(4) The current lamp output can be acquired using the applicable GET command. ("
GET LAMP ")
Example
Setting
> LAMP=NORMAL
The lamp output is set to “NORMAL”.
< i:OK
Reference
> GET LAMP or ?LAMP This retrieves the lamp output.
< g:LAMP=SILENT
* Commands are indicated by ">", and responses are indicated by "<".