Jeep 2013 Wrangler - Manual (Page 198)

1. Remove the swing gate bar (black metal bar for
bottom of rear window) and set aside.
NOTE: Be sure the wire harness in the left rear corner is
not tangled in the soft top bows before you lift the top.
2. Unsnap and remove the black boot cover. This cover
should be discarded. It was intended as a protective
cover for shipping only.
NOTE: A visual instruction sheet is enclosed in the dual
top wrap.
3. Put up the soft top. Refer to “Soft Top — Putting Up
The Soft Top” in this section.
DUAL TOP — FOUR-DOOR MODELS —
IF EQUIPPED
If your vehicle is equipped with a Dual Top, you must
remove one of the tops from the vehicle. If the soft top
is removed, the pivot brackets must also be removed
from the sport bar.
The soft top was installed at the
factory for shipping purposes only. The soft top and the
hard top are to be used independently.
Removal is
mandatory to prevent any possible wear and tear on the
soft top. Your vehicle warranty will not cover damage
resulting from both tops remaining on the vehicle at the
same time for extended periods of time.
196 UNDERSTANDING THE FEATURES OF YOUR VEHICLE